40408 Media Handler MDH: Please close plate cover Trendsetter_400/800 Trendsetter_400/800_Autoloader Trendsetter_NEWS Trendsetter_Series_4 Either the plate cover door is open or there is a problem with the sensor. This error is reported if the plate cover door is open and either the picker or the plate separator arms attempt to move. The sensor status may be checked by using the PICKER command. The sensor status should read TRUE if the plate cover sensor is activated. With the key-switch in the normal position, the picker cannot move unless this sensor indicates that the door is closed. Disabling the sensor through firmware does not allow the picker to move. Close the hinged plate cover door and select the RESUME button on the workstation dialog box. Call the Response Centre if the problem persists. This error is reported. The plate cover door is probably open. The plate cover door may be obstructed by something. The plate cover door sensors may be damaged, or not adjusted correctly. The wiring to the sensors may be disconnected or damaged. 23-NOV-2001 Created. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:26 2008 PST